Page 21
Page 20
MagnaPool™ | Installation Manual
<
AUX 2 / LIGHT
-OFF
-ON
-DEFINE COLOR
<
COLOR LIGHT
-ALPINE WHITE
-SKY BLUE
-COBALT BLUE
-CARIBBEAN BLUE
-SPRING GREEN
-EMERALD GREEN
-EMERALD ROSE
-MAGENTA
-VIOLET
-SLOW SPLASH
-FAST SPLASH
-AMERICA
-FAT TUESDAY
-DISCO TECH
Note:
Colour sequence is relevant for Zodiac colour
lights only. If other manufacturers lights are
installed the colour selection will vary
8.3
pH Sensor Calibration
The pH sensor may be calibrated in 1 point
calibration or 2 point calibration (pH 4 and pH 7); 2
point calibration is recommended.
1. Turn on power to the controller.
2. Turn off the pool pump and close valves as
necessary to isolate the cell and sensors.
3. Press
.
4. Use
to select “pH Setup” then press .
5. Use
to select “pH Calibration”
then press .
6. Use
to select “ 1 Point”, or “ 2 Points”,
then press .
7. Remove the pH sensor from the POD.
8. Insert the pH sensor into the
pH 7 buffer solution.
9. Press
while “Start” is selected.
10. Press
while “Go to Step 2” is selected.
11. Rinse the pH sensor with tap water.
12. Insert the pH sensor into the pH 4 buffer
solution.
13. Press
while “Start” is selected.
14. Press
while “Continue” is selected.
15. Press
to exit.
8.2.1
Assign Lights
1. Press
.
2. Use
to select “Aux/Light” then press .
3. Use
to select “Assign Lights” then press .
4. Use
to select “Aux 2” then press .
5. Use
to select “Yes” then press .
6. Use
to select “White Light” or “Color
Light” then press .
7. Press
to exit.
<
-AUX/LIGHTS
-PROGRAMMING
-LOW MODE
-SLAVE MODE
-REVERSING
-HELP MENU
-LANGUAGE
MAIN MENU
<
AUX/LIGHTS
-ASSIGN LIGHTS
-AUX 2
-AUX 1
<
ASSIGN LIGHTS
-AUX 2
-AUX 1
<
AUX SETUP
AUX
2 = LIGHT?
YES
NO
<
AUX
2 = LIGHT
-WHITE LIGHT
-COLOR LIGHT
8.2.2
White Light Operation
1. Press
.
2. Use
to select “Aux/Light” then press .
3. Use
to select “Aux 2/Light” then press .
4. Use
to select “On”, “Off”,
or “Set Timers”, then press .
5. Press
to exit.
<
AUX 2
-OFF
-ON
-SET TIMERS
8.2.3
Color Light Operation
1. Press
.
2. Use
to select “Aux/Light” then press .
3. Use
to select “Aux 2/Light” then press .
4. Use
to select desired color, “Off”,
“On” or “Define Color”, then press
.
5.
If “Define Color” selected, use
to select
desired color then press .
6. Press
to exit.