zmorph3d.com
23
Set the printing temperature
to the PLA material. Nozzle
200 °C, bed 60 °C.
To to that tap the gaps and
type the temperature on the
keyboard.
Wait for extruder to heat
up. When done tap ‘NEXT’.
Apply your choice by pressing
the ‘NEXT’ button.
Zmorph Fab calibration is
complete.
Clean the bed. Your machine
is ready for your first print!
Use the arrow buttons on the
screen to feed the material
on both sides of the extruder
until it start to pour out from
the nozzle. (it might take
a couple times), after that
press the ‘NEXT’ button.
Wait for the machine to
finish printing pattern.
Look at the printed lines
and select the best one on
the screen. A correct line is
the one that sticks to the
table after gently touching
it with the finger, but can
be easily ripped off with a
fingernail.
NONE, REPEAT PRINTING
1
2
3
4
5
NEXT
Choose the best printed line
(numeration from left to right)
LOAD FILAMENT
LEFT
RIGHT
ALL
NEXT
BACK
Calibration complete!
DONE
NEXT
BACK
CURRENT
TARGET
NOZZLE
BED
NEXT
BACK
TARGET
NOZZLE
BED
CURRENT
Dual Extruder Toolhead
210
210
210
210
60
60
60
60
80mm
80mm
80mm
