Page 18 of 20
Hydro Tap Installation and Operating Instructions - 86682 - March 2012 v1.05
Trouble Shooting
Symptom
Possible Cause
Solution
No LED display, no tap head
lights or, no water when tap
levers are operated.
No water flow.
Slow water recovery after
use.
Water not hot.
Water not chilled.
No power.
Plug is not located in power
socket.
Tap loom is not connected to
HydroTap unit.
Possible internal fault.
Program in OFF cycle
Water supply isolated.
Water supply not connected.
Power supply not connected.
Tap loom is not connected to
HydroTap unit.
Possible internal fault.
Program in OFF cycle.
Filter may require replacement.
Unit is in Sleep Mode.
Unit has just come out of OFF
cycle.
Possible internal fault.
Excessive use, unit refilling or
chilling down to temperature.
Possible internal fault.
Check power supply.
Ensure power plug is correctly fitted and switch is
turned ON.
Check loom connection.
Contact local Zip Service Provider.
Check LCD for information.
Check water supply is on.
Check to ensure plumbing connection is made.
Check power plug is correctly fitted and switch is
turned on.
Check for loom connection
Contact local Zip Service Provider.
Check LCD for information.
Check filter usage on LCD screen, if “filter
change” is displayed follow instructions
on page 16, 17 & 18.
Touch Hot lever and wait for Red LED to stop
flashing.
Wait for Red LED to stop flashing.
Contact local Zip Service Provider.
Wait for Blue LED to stop flashing.
Contact local Zip Service Provider.
Alternating display messages: More than one fault identified
at the same time
Record the number and type of faults
Contact local Zip Service Provider
Warning:
If the Zip HydroTap is switched off for a long period of time (e.g.
More than a weekend), run water through the chilled water outlet for at least 5
minutes before consumption.
15. Scroll through the menu to “Filter Used (Days)”, press adjust
>
to reset
the timer. Press adjust
>
and it asks “are you sure”. Press adjust
>
again
to lock in the command. After approx 10 seconds it will default to the
selected mode.
16. Close the door to secure the appliance.
Internal Filter Replacement
(continued)
