Hydro Tap Installation and Operating Instructions - 86682 - March 2012 v1.05 Page 15 of 20
Normal Operation
Set Time
To change time, press either Menu
>
or Menu
>
button until Set Time is on the
display screen. Press
>
Adjust button to increase time or
>
Adjust button to decrease
time. Time increases or decreases in increments of one minute. Hold the Adjust buttons
down for rapid increases or decreases. The time will be displayed in 24Hr mode.
Set Day
Press either Menu
>
or Menu
>
button until Set Day is displayed.
Press
>
Adjust or
>
Adjust to select day.
Filter Life
( Factory set at 6000 Ltrs )
Press either Menu
>
or Menu
>
button until Filter Life is displayed.
Press
>
Adjust button to increase Filter Life or
>
Adjust button to decrease Filter Life.
Filter Life increases in 1000 Ltr increments to a maximum of 10000 Ltrs.
Reset Litres Filtered
This function is to reset the Filter Change display after a filter has reached the end of
its life (refer to “Replace Filter Instructions” section of this document).
Press either Menu
>
or Menu
>
button until “Litres Filtered” is displayed. Press
>
Adjust once and “Reset Counter” will be displayed, press
>
Adjust button once and
“Are You Sure” will be displayed.
Press
>
Adjust once and “Litres Filtered” will be reset to 0.
Activating Sleep Mode
This mode allows the HydroTap to go into Energy Saving mode. In this mode the unit
will go to “sleep” after a predetermined period of inactivity. Press either Menu
>
or
Menu
>
button until “Sleep Mode” is displayed.
Press
>
Adjust once to select
Option 1:
Sleep to 65ºC after 2 hours of NO USE
Press
>
Adjust once to select
Option 2:
Auto OFF after 2 hours of NO USE.
When the period of inactivity passes, the display will show “Sleep Mode”. During the
“Sleep Mode” the Red LED on top of the tap lever will flash slowly.
Sleep to OFF means the Boiling and Chilled circuits will be switched OFF
To de-activate the sleep mode, momentarily operate the Hot lever and then allow
sufficient time for the water to reach the set temperature
Activating 7 Day Timer On / Off Mode
Press the Menu
>
or Menu
>
button until “Monday On” is displayed. To set the time
for the unit to turn on press
>
Adjust button until required time is reached.
To set the time for the unit to turn Off press Menu
>
button once and “Monday Off”
will be displayed. Now press
>
Adjust until required time is reached.
If each individual day is to have an “On / Off” time, these steps need to be repeated for
each day and for each On / Off time.
Note:
The Hydrotap may be
temporarily activated by
operating the HydroTap
levers, the unit will go into
normal operation and then
remain in an “ON” cycle,
until the next “OFF” cycle.
Setting the Energy Saver Timer
(products with this feature only)
