Page10 INSTRUCTION MANUAL CENTRAL COMMAND STATIONS MX10, MX10EC
3.
Typical system arrangement
3.1
Startsets with the Maus
“Normal ZIMO start sets” (see first part of this chapter) contain a ZIMO controller additionally to the central
command station (either MX32 or MX33, depending on time of delivery);
The start set with the maus, on the other hand, contains a
ROCO WIFI Maus
as single controlling unit,
together with a preconfigured router (in two different versions)
1 central command station
MX10
results in
STARTWM
or MX10EC
(Economy)
results in
STARTECWM
1 power supply unit
NG300
(320 VA)
1 Multimaus
Roco WIFI-Multimaus
1 WIFI router
(type depends on availability)
As well as various plugs, CAN cable, Power cable (depending on the country you maybe need an
adapter or a replacement).
The start set
STARTECWM
provides a cost-efficient start into the ZIMO control system; nevertheless it
is very powerful: up to 12 A rail current (also for large-scales of 222V) and of course with all typical
ZIMO festures.
The
added router
in this start sets are
preconfigured
, so the startup of the WIFI Multimaus works
without problems and you can immediately start maneuvering the trains. Naturally, the Roco
Z21 app
can be used at any time.
In case the WIFI connection does not work immediately, see chapter “Roco WIFI Z21 APP2 and WIFI
Multimaus.
Of course, some of the ZIMO-typical features and display variations are not available in the start set
with the Maus (without a ZIMO controller): no loco pistures, no function icons, no speedo, no broad-
cast stop, no RailCom feedback, no CV reading in POM (i.e. on the main track - also “OP PROG”),
etc. - nevertheless, the central command stations MX10 and MX10EC are prepared for an
extension
with ZIMO controllers (MX32, MX33) including the radio versions (see picture).
How to handle the Roco WIFI Maus is de-
scribed in Roco’s user manual:
Z21 WLANMAUS Manual (DE, EN, FR)
This link is valid at the time of publication of this instruction
manual. It is possible, Roco changes the location.
Here - within the instruction manual of MX10 and
MX10EC - only the typical start up is described, i.e.
how the first train is maneuvred and the first turnout
is switched.
Usually, the loco to be maneuvered has to be
entered into the “library” (the easiest way is en-
tering the address), to be acble to select and
maneuvre it.
The WLAN mouse and router included in the ZIMO starter kit are already correctly set to ensure imme-
diate operation. If there are any problems or the devices were not purchased within a start set, see
chapter "Roco Z21 and WLAN mouse“.
SWITCH ON the WLAN Maus which has been switched off until now with
"WLAN" is displayed, then the name of an active locomotive.
Use
to scroll through the entries in the selection list until the display shows "
NEW?
”,
confirm with to start entering the new name with the numeric keys
(at least 1 letter must be entered!)
Confirm finished name with to enter the address with
Confirm the entered address with to select speed step mode (128 suggested),
confirm all entries with , new locomotive is included in selection list,
Maneuvre
….
SWITCH OFF the WLAN Maus through
MENÜ
+
press simultaneously
