INSTRUCTION MANUAL CENTRAL COMMAND STATION MX10, MX10EC Page31
8.5
BaseCab OP PROG (Programming CVs via the central station)
Starting point is the “BaseCab LOCO” screen
GREEN
(see chapter 8.4)
Press
button
1
(
) LONG
screen stays
GREEN
- “BaseCab OP PROG” screen
This screen can also be reached via the menu
BaseCab OP PROG
(see chapter 8.8).
adjust the tagged value (=CV
number) with the rotary knob according to your
wishes.
Press rotary knob
fix
adjusted CV number; go to next field (e.g. CV val-
ue)
adjust the tagged value (=CV value) with the rotary knob according to your wishes.
Press rotary knob
program adjusted value into decoder; open next line
If programming was successful (acknowledged by RailCom feedback) the MX10 displays: „ACK RC“
If there is no feedback from the decoder,
the display shows “SENT” instead of
“ACK”
Press rotary knob again
open next line
Read CVs:
As above (program CVs), but:
Do not enter CV value, but immediately
press rotary knob, feedback “READ”
LEAVING “BaseCab
: press
button
3
(
) LONG
back to LOCO or MENU
8.6
BaseCab SERV ADR (addressing decoders)
Via the MENÜ (se chapter 8.8)
(the menu can also be reached from
“BaseCab LOCO”, by pressing
button 2 (MENU)
LONG)
Set “BaseCab SERV ADR” in the menu and
Press rotary knob
screen colour changes to
YELLOW
,
“BaseCab SERV ADR” screen
adjust the tagged value (=address) with the rotary knob according to your wishes.
Press rotary knob
program adjusted address into decoder
Read out address:
As described above, but: do not enter CV value, but immediately
Press rotary knob, feedback “READ”
8.7
BaseCab SERV PROG (programming CVs)
Via the MENÜ (se chapter 8.8)
(the menu can also be reached from
“BaseCab LOCO”, by pressing
button 2 (MENU)
LONG)
Set “BaseCab SERV PROG” in the MENU and
press rotary knob
screen colour changes to
YELLOW
, “BaseCab SERV PROG” screen
adjust the tagged value (=CV number or value) with the rotary knob according to your wishes.
Press rotary knob
fix adjusted value, program into the decoder
Read CVs:
As above (for programming CVs), but:
do not enter CV value, but immediately
press rotary knob, feedback “READ”
LEAVING “BaseCab
: press
button
3
(
)
back to MENU
THIS FUNCTION IS NOT YET IMPLEMENTED - THIS IS A DESCRIPTION OF THE PROJECT
THIS FUNCTION IS NOT YET IMPLEMENTED - THIS IS A DESCRIPTION OF THE PROJECT
THIS FUNCTION IS NOT YET IMPLEMENTED - THIS IS A DESCRIPTION OF THE PROJECT
O P P R O G 1 0 1 6
D C C
C V 2 3 = . . .
Auf OP PROG umschalten
OP PROG 1016
DCC
CV . . .
O P P R O G 1 0 1 6
D C C
C V 2 3 = 1 5 8 A C K R C
OP PROG 1016
DCC
CV 23 = 158 SENT
O P P R O G 1 0 1 6
D C C
C V 2 3 = 1 5 8 A C K R C
C V . . .
SERV ADR
SERV PROG
SERV PROG
NOTE: Scrolling back to finished programming and reading lines is NOT possible.
NOTE: Scrolling back to finished programming and reading lines is NOT possible.