Page4 INSTRUCTION MANUAL CENTRAL COMMAND STATIONS MX10, MX10EC
Display (128 x 32, RGB backlight)
Normal screen
BLUE
Voltages, currents, track 1 / 2, communication statistics, AOS
VOLT & AMP main configuration
YELLOW
Output voltage, maximum current track 1, track 2
, T. 1 (
)
VOLT & AMP detailed configura-
tion
YELLOW
All possible configurations concerning voltage and current, such as:
Turn-off times, tolerance
2 sec
STOP & OFF
RED
Broadcast Stop BCS, OFF track 1, track 2, overcurrent OVC (short cir-
cuit)
Button 3 (
)
BaseCab LOCO
GREEN
Set loco address, drive with rotary knob, activate functions per buttons
Button
2
MENU
GREY
Select menu points by scrolling and pressing the rotary knob
M,
,
DCC SERV PROG settings
YELLOW
CV programming and read-out on the programming track (track 2)
M,
,
MX10 Config
GREY
Various settings like language, radio channel, sniffer input, booster, etc.
Information on software version, information statistics, date/clock, etc.
flash drive.
UPDATE & SOUND
GREY
Update decoder and load sound from the flash drive
Legend:
Turn rotary knob fast
rotary knob scrolling
Rotary knob pressing
Button 1
M
button 2
button 3
USB (Host) socket
Slot for the flash
drive.
Insert
UPDATE
& SOUND
Select files to up-
date the decoder or
to load sound,
also for MX10’s self-
update.
Rotary knob
Normal operation
BLUE
- protection against erroneous activation: Press and rotate shortly
NO effect
(Rotated fast)
.
operating state VOLT & AMP main settings
(screen
YELLOW
)
.
(Press long: 2 sec)
Broadcast Stop BCS and operating state STOP & OFF (
screen
RED
)
(Press 1 sec)
cancel broadcast stop, back to normal operation (or to operating state active before)
(Press long: 4 sec)
.
SYSTEM STANDBY (track 1, 2 OFF, controller-supply OFF, display OFF, etc.)
Beyond normal operation (screen) -
scroll and
select,
adjust
drive
direction, ...
ZIMO CAN and XNET sockets
- for a 6-pole connection to ZIMO control-
lers and modules; additionally on the 8-pole
socket: Sniffer inputs.
Note: Stationary equipment modules StEin are
NOT connected to this CAN socket, but to the
socket on the rear side of the MX10.
The XNET socket is for the connection to
ROCO Multimaus and others; additionally
on the 8-pole socket: second ZIMO CAN
bus and second XNET bus (in reserve).
SUSI connection
Fast sound loading via SUSI
interface.
3 buttons
Normal operation, normal screen
BLUE
-
Button
1
(
)
operating sequences OPS, settings and control
Button
2
(
MENU
)
Menu to select operating states
GREY
Button
3
(
)
operating state “BaseCab LOCO”
GREEN
STOPP & OFF (after pressing rotary knob 2 sec
or short circuit)
RED
Button
1
BCS, OFF, ON track 1 button
2
... track 2
BaseCab LOCO
GREEN
Buttons
1, 2, 3
(after selecting a group)
controlling functions
UPDATE & SOUND
BLUE (
GREEN
)
Button
1
Start decoder update
Button
2
Start sound loading
Button
3
(if not used differently)
back to normal screen
(
BLUE
)
