9.8 Menu group Info
Info
Menu group Info
Info for mode speed controller
1.01
Speed
Speed
Motor current
Display of motor current (Metering precision approx. +/-10%)
Set extern
Display of the currently active default signal.
The percentage corresponds to the internal actuation of the power component
under consideration of the settings
“
Min. speed
”
and
“
Max. speed
”
.
0 - 100 %
≙
0 - 10 V, 10 - 0 V, 0 - 20 mA, 20 - 0 mA, 4 - 20 mA, 20 - 4 mA
Display:
The device operates at:
Set
“
external1
”
Signal to
“
E1
”
/
“
GND
”
Set
“
External2
”
Signal to
“
E2
”
/
“
GND
”
Set
“
Intern1
”
Menu
“
Set Intern1
”
Set
“
Intern2
”
Menu
“
Set Intern2
”
Info for mode controller
2.01
...
6.01
E1 Actual
Current actual value measured on the sensor 1.
Depending sensor-type in: mbr, m
3
/s, m/s, Pa, %, bar, m
3
/h,
°
C, V, mA, etc.
E2 Actual
For operation with two sensors display for
“
2 actual
”
.
If function not active, display
|
- - - - -
|
Setpoint1
Display of the active target value at which the device operates.
“
Setpoint1
”
Menu
“
Setting
”
“
Setpoint2
”
Menu
“
Setting
”
“
Ext. Setpoint
”
= setting by external signal 0 - 10 V. With activated manual
mode the display constantly changes between actual value and value for
manual mode.
Speed
Speed
Motor current
Display of motor current (Metering precision approx. +/-10%)
Msco.
Momentarily status for minimum speed cut off
“
ON
”
= switch off, if Setpoint (+/-
“
Min. speed cut off
”
) is reached.
“
OFF
”
= no switch off that means operation with minimum rate of air.
Operating Instruction
Econtrol
–
model series EXDM
Programming
L-BAL-E008-GB 0945 Index 005
Part.-No. 00156742-GB
47/85
