ZIEHL-ABEGG Econtrol EXDM, Operating Instruction

Page: 57 / 86

9.10.3.4Limit ON / OFF, Function
|
3D
|
The value for “ Limit ” adjusted in the Controller Setup, is activated over a digital input.
Contact e.g. at ditgital input “ Digital In 1 ” (depending on device type at terminals “ D1 ” - “ D1 ” or “ D1 ” -
“ 24 V ” ).
For “ D1 ” Inverting “ OFF ” , limitation active at closed contact.
Controller
24V
D1 D1
1 0
n = 0- 80 % 1
0
- - - - -
n = 0- 100 %
10.05.2007
v_3d_limit.vsd
1
1 Setting “ Limit ” (depending on device type in: %, Hz, rpm)
9.10.3.5 Switch over Input signal “ E1 ” / “ E2 ” , Function
|
4D
|
Switch over between Input signal 1 (Analog In 1 terminal “ E1 ” ) and input signal 2 (Analog In 2 terminal
“ E2 ” ).
Contact at digital input e.g. “ Digital In 1 ” = terminals “ D1 ” - “ D1 ”
D1 D1
1 0
n = 0- 100 %
0
1
Si 1
Si 2
E1
GND
E2
GND
Si 1
Si 2
10.05.2007
v_4d_umschaltung_e1_e2.vsd
Controller
Si 1 Signal 1
Si 2Signal 2
For mode speed controller ( 1.01 ) Base setup for “ E2 Analog In ” :
|
1E
|
necessary.
For modes controller (higher 2.01 ..) Base setup for “ E2 Analog In ” :
|
7E
|
necessary (as far as
otherwise does not occupy).
9.10.3.6 Set 1/2 or Setpoint 1/2, Function
|
5D
|
Switch over between “ Set Intern1 ” and “ Set Intern2 ” (for speed controller 1.01 )
Contact e.g. at ditgital input “ Digital In 1 ” (depending on device type at terminals “ D1 ” - “ D1 ” or “ D1 ” -
“ 24 V ” ).
Controller
24V
D1 D1
1 0
n = 40 % 1
n = 80 %
0
- - - - -
- - - - -
11.05.2007
v_5d_vorgabe_intern_1_2.vsd
2
1
1 Setting “ Set Intern1 ” (depending on device type in: %, Hz, rpm)
2Setting “ Set Intern2 ” (depending on device type in: %, Hz, rpm)
•
“ D1 Inverting ” = “ OFF ” : “ Set Intern1 ”
at opened contact / “ Set Intern2 ” at
closed contact.
•
“ D1 Inverting ” = “ ON ” : “ Set Intern1 ” at
closed contact / “ Set Intern2 ” at
opened contact.
Operating Instruction Econtrol – model series EXDM Programming
L-BAL-E008-GB 0945 Index 005 Part.-No. 00156742-GB
56/85