126 of 168
MAINTENANCE AND USE MANUAL
EN
SATOVAC
Modifications which alter the equipment characteristics from a safety and risk
prevention viewpoint may only be made by the Manufacturer who shall then issue
a certificate stating that the equipmente conforms to safety standards. Therefore any
modification or maintenance tasks not actually described in this manual are to be
considered forbidden. If the machine is modified, tampered with or repaired by
unauthorised personnel or non-original spare parts are used the manufacturer is
relieved of all responsibility. If a maintenance task is required but is not described
in this manual you must contact an Authorised Servicing Centre.
8.4
RESTARTING AFTER A LONG PERIOD OF INACTIVITY
Should the machine be used after remaining idle for a long period proceed as described in Chap. 6
(start-up)
If there are any faults or malfunctions proceed as described in Chapter 9 (Troubleshooting). If the
problem persists or is not covered by the information in this chapter contact your Authorised
Servicing Centre immediately.
8.5
REQUESTING TECHNICAL ASSISTANCE
To obtain technical assistance choose one of the following options:
1. contact your Authorised Servicing Centre.
2. telephone the Zhermack Customer Assistance Service on the number +39 0425.597.611 and
proceed as follows: give personal data (e.g. address and telephone n.), state the information on the
equipment ID plate (see paragraph 3.3) and explain the problem clearly.
3. fax all the above information and a properly filled out ID Form (see Appendix 2) to +39
0425.53.596.
Summary of Contents for C306700
