ZAHD, ZAEHD 150/200-155/175
32
Installation
www.zepro.com
4.8
Controllers
1. Install
the primary controller on the side of the vehicle normally facing away from the traffic. The distance
between the vehicle’s rear edge and the centre of the controller must be 300-600 mm. Connection is
performed later in section
6 if this is not already done from the factory.
2. Any additional controllers can be installed in an optional location. Connection is described later in section
6.
Image 52. Installing controllers
Image 53. Installing controllers
m
WARNING!
The primary controller must always be fitted on the side that is facing away from moving traffic. Fitting in any other
way involves increased risk of injury.
300-600 mm.
IMPORTANT!
The controller’s cable intake must always face downwards.
Pay attention and be careful when running cables to get longer life for the cables and to reduce the
risk of unnecessary downtime.
The cable must not be fastened to brake lines or the vehicle’s normal electrical system.
The cable must be protected by rubber grommets when it passes through beams or walls.
Cables must be installed sufficiently far
from, or be protected against, sharp edges so they cannot chafe
or otherwise sustain damage that could lead to a short-circuit and cable fires.
Take care not to bend cables with too tight a radius as this can cause damage.
Summary of Contents for ZAHD 150/200
Page 2: ......
