ZAHD, ZAEHD 150/200-155/175
22
Installation
www.zepro.com
7. Align and install the chassis brackets on the vehicle chassis. Install with at least 3 x M14x45 10.9 bolts at
the front and rear edges of the bracket. Install with the nut on the inside of the vehicle chassis, see Image
26. Tighten the bolts using a torque wrench.
Tightening torque: 115 Nm.
8. Align and install the support frame on the chassis brackets. Install with at least 3 x M14x45 10.9 bolts in
the upper and lower rows of holes. The distance between the outer bolts must be at least 200 mm, see
Image 28. Install with the nut on the inside of the bracket, see Image 27. The chassis brackets’ slot-shaped
holes facilitate fine adjustment of the lift’s position. Perform fine
adjustment if necessary before tightening
the bolts.
9. Tighten the bolts using a torque wrench. Tightening torque: 115 Nm.
NOTE!
Welding is not permitted on the chassis brackets.
Do not move the lift all the way to the armstops or with the platform fitted before all the bolts are fully
tightened against the chassis.
Do not place the lift under load until all bolts are tightened.
10. Remove the mounting jig.
Min. 200 mm.
Image 26. Install the chassis bracket
with at least 3 x M14x45 10.9 bolts at the
front and rear edges of the bracket.
Image 27.
Install the support frame with
at least 3 x M14x45 10.9 bolts in the up-
per and lower rows of holes.
Image 28. The distance between the out-
er bolts must be at least 200 mm.
Summary of Contents for ZAHD 150/200
Page 2: ......
