ZAHD, ZAEHD 150/200-155/175
Installation
25
www.zepro.com
Lock screws x3
Out
In
Image 35. Adjusting the fit with the vehicle body.
Image 36. Adjusting the tilt angle
4. Turn the adjusting collar so that the platform just
meets the seal on the vehicle body, see Image 35 (A).
5. Loosen the three lock screws on the other tilt
cylinder, see illustration.
6. Turn the adjusting collar so that the tilt cylinder aligns
with the attachment on the platform, see illustration.
7. Fit the other tilting cylinder to the platform mount-
ing. Use the supplied shaft and support wheel.
8. Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
9. Adjust the two cylinders alternately so that the
platform meets the vehicle body, see Image 35 (B).
10. Tighten the lock screws of the adjusting collar
using a torque wrench
Tightening torque: 3-5 Nm.
Image 37. Fitting the tilt cylinder to the platform
IMPORTANT!
The max. length of both cylinders must be adjusted
equally to avoid unwanted breakout forces.
IMPORTANT!
Make sure the cylinder Is installed with the grease
nipple facing up.
Summary of Contents for ZAHD 150/200
Page 2: ......
