Z 1500/2000-135/155/175
Testing and verification
65
www.zepro.com
11
Testing and verification
Testing and verification of the tail lift takes place in accordance with the installation/delivery inspection.
Verify that the tail lift is suitable for the vehicle in question and for the intended use.
11.1 Static load test
11.1.1 Deformation
•
Position the tail lift half way to vehicle floor level and with the platform horizontal. Measure
dimensions A-B-C-D for comparison as illustrated.Figure 97
• Place a test load on the platform, as shown in table (for each lift model/lift capacity).
• Remove the test load from the platform.
• Repeat the measurement of A-B-C-D and verify that there has been no deformation of the lift or its at-
tachment point.
11.1.2 Operation
• Place a test load on the platform, as shown in the table. The tail lift must be at the same level and angle
as the vehicle floor.
Leave the test load for 15 minutes.
• Verify that platform operation is not more than 15 mm in the vertical direction (points A and D) and not
more than 2° in the angular direction (points B and C), in relation to the vehicle floor level.
11.1.3 Static load (Test load 1.25 x tail lift loading capacity). For tail lifts with a load
centre of 1000 mm.
Capacity
Load 1500 kg
Load 2000 kg
Distance out on platform (L)
1500 kg
1250 mm
-
2000 kg
1625 mm
1250 mm
Figure 97.
Testing and verification
Max 2º
Max. 15 mm
B
D
C
A
B
D
C
A
Vehicle floor le
vel
Deformation
Operation
Summary of Contents for Z 1500
Page 2: ......
