Z 1500/2000-135/155/175
Installation
35
www.zepro.com
4.10.1 Controllers 3+1 (CD 1)
1. Fit the controllers in the desired locations. However,
locate them such that the operator’s working posi-
tion is as safe as possible, and with an adequate
overview of the load, tail lift and their working area.
2. The distance between the vehicle’s rear edge and
the centre of the controllers must be 300-600
mm. The distance between the controllers must
be at least 260 mm. See
Figure 60.
3. Any additional controllers can be installed in an
optional location.
4. Run the controller cabling to the tail lift cable grom-
met. Connection is described later in section 6.
Figure 60. Installing controller CD
1 with two-handed grip.
Min. 260 mm.
300 - 600 mm.
4.10.2 Controller UCU (CD 19)
Installation on the outside of the body
Because the cable is usually connected to the controller, and the latter is always bolted to the bracket,
disconnect the cable from the controller to run it through the wall.
1. Raise the connector latch to pull out the connector.
See Figure 61.
2. When the cable has been pulled through the wall, reconnect it to the controller and secure it using the
latch. Then attach the controller securely to the body with the screws.
See Figure 62.
Figure 61.
Disconnecting the connector
Figure 62.
Installing controllers
300-600 mm.
Summary of Contents for Z 1500
Page 2: ......
