Z 1500/2000-135/155/175
20
Installation
www.zepro.com
4
Installation
Zepro tail lifts are only approved for installation with Zepro
assembly kits.
m
WARNING!
4.1
Frame
1. Measure and mark the midpoint of the vehicle's
rear beam. See
Figure 25.
2. Fasten or spot-weld the assembly jig to the rear
beam so that each
centre point aligns. See
Figure
26. Art. no. 51724TL for Z 1500/2000.
3. Position the support frame under the vehicle
frame.
4. Raise the lift arms to their highest position.
5. Attach the lift arms to the lugs on the jig. Use the
steel platform’s regular pivots.
6. The support frame should be positioned as high
as possible within the specified C dimension.
Adjust the frame to the ideal height under the
chassis. Use the lift's packaging and a forklift,
See
Figure 27. The frame must be positioned par-
allel with the floor of the vehicle body and must
not be in contact with the vehicle frame; there
must be a few millimetres of play. If necessary,
adjust the angle of the arms by carefully operat-
ing the lift.
7. Install the brackets on the support frame so that
its opening is facing towards the front of the
vehicle, and adjust the position of the frame so
they are in contact with the vehicle frame.
8.
Install the U-profile with associated washers and
nuts, but do not tighten them. Screw the nuts on
alternately until the U-profile is flat against the
body, see Figure 28
Figure 25.
Measure and mark the mid
-
point of the rear beam of the vehicle
Figure 26.
Fasten or spot-weld the assembly jig to the
rear beam
Art. no. 51724TL for Z 1500/2000
Figure 27.
Use the lift's packaging and a forklift
.
Figure 28.
Install the U-profile with as
-
sociated washers and nuts
NOTE!
Also refer to the relevant vehicle manufacturer’s vehi
-
cle body instructions and Zepro’s instruction manual
before installation.
Summary of Contents for Z 1500
Page 2: ......
