Z 1500/2000-135/155/175
22
Installation
www.zepro.com
When installing on chassis with pre-drilled holes
15.
Bolt the mountings securely on the exterior
of the vehicle frame. Install in the slot-shaped
holes with at least 6 screws. Use suitable bolts
(strength M14 10.9 or higher) and install the
associated washer and nut on the inside of the
vehicle frame. Install the bolts but do not tighten.
See
Figure 31
.
16.
Check and fine trim the lift’s position.
Then tighten
the bolts with a torque wrench.
Tightening torque:
Standard for selected screw.
17. Using a torque wrench, tighten the nuts holding
the U-profiles.
Tightening torque: 280 Nm.
18. Drill holes in the vehicle frame for attachment
bolts in each of the brackets’ two upper round
holes. Use suitable bolts (strength M14 10.9 or
higher) and install the associated washer and
nut on the inside of the vehicle frame. See
Figure
31
.
Tighten the bolts with a torque wrench.
Tightening torque: Standard for selected screw.
m
WARNING!
Welding is not permitted on the chassis brackets.
Do not run the lift against the arm stop or with the
platform installed until all bolts are properly tightened
against the frame.
Do not place the lift under load until:
- the correct number of bolts are installed and
tightened to torque.
- the body is mounted to strengthen the truck frame.
19. Remove the mounting jig.
Figure 31. Install the frame mount to a ve-
hicle frame with pre-drilled holes
Summary of Contents for Z 1500
Page 2: ......
