Touch-MyDesign
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
25
The parameters that are shown here by default are
Function
and
LED Lighting
. The
available options for the latter will depend on the selected
function
:
Disabled
: this option (selected by default) entirely disables the functionality of
button Xi, however there will still be the possibility of selecting (through the
“LED indicator” parameter) whether the associated LED behaves regularly
(“Active”) and therefore turns on for a few instants whenever a press happens
on the button (and afterwards turns off), or remains totally inactive.
1-bit
: permits sending a certain binary value, B (“0”, “1” or an alternating
value), through the “[Xi] Binary control: B” object, visible after assigning this
functionality to button Xi.
The
LED lighting
parameter permits, for its part, two alternatives for the
behaviour of the LED corresponding to the button:
Regular
: the LED will behave in the usual way: when a touch on its
button is detected, it will light (according to the custom “ON” level, in
parameterised) for a few instants and it will then turn off again
(according to the custom “OFF” level, if parameterised).
State-dependent
: the light state of the LED will depend on the current
value of the “[Xi] Binary control: B” object, so it will remain in the “ON”
state whenever the value of the object is “1” and in the “OFF” state when
the value is “0”. Note that, in this case, the described behaviour does not
depend on the parameterised value B (i.e., on the value that is sent to
the bus when the button is touched).
Example
:
assume that, from the General parameter window, a
custom lighting has been set, consisting in an ON level equal to
“maximum” and an OFF level equal to “minimum”. Also assume that a
certain button has been programmed as a switched 1-bit control, and,
for its respective LED, the “state-dependent” mode has been
selected. In such case:
•
Whenever the object that corresponds to the button shows the
value “1”, the LED will be lighting at the maximum power level.
