Touch-MyDesign
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
37
dimming (Toggle) (after the first press the bus will be sent an order to
increase the light level according to the parameterised light step: 100%,
50%, 25%, 12.5%, 6.25%, 3.1% or 1.5% (see
Table 2
), while after the
second press, the value “8” will be sent; and so on after any subsequent
presses, commuting the value every time) and Light dimming (toggle) (a
combination of the two previous cases, according to the sequence increase
light → stop → decrease light → stop)
.
Sending of a Scene
: the KNX bus will be sent a certain scene value
through the “[Ix] [Short Press] ACTION” object, where “ACTION” will
depend on the action configured in the corresponding screen displayed by
ETS:
Figure 26
Short Press: Scene (Inputs > Push Button)
The available actions are:
Run Scene
: the bus will be sent the order to run a scene, i.e., the
scene number set for the “Scene” parameter will be sent, decreased
by 1 according to the KNX standard, so that other devices linked to
the same object execute the corresponding scene (that is, a
predefined joint reaction).
Save Scene
: the bus will be sent the order to save a scene, i.e., the
scene number set for the “Scene” parameter will be sent, increased
by 127 according to the KNX standard, so that other devices linked
to the same object overwrite the reaction previously defined for such
scene number.
Long Press
: permits setting a reaction when a long press takes place. It is
completely analogous to the above “Short press” parameter, so please refer
to that section for further information.
