INSTALLATION SETUP
PV152
1-5
PRO1200 INSTALLATION SETUP
viewing from the rear of the projector).
To remove the vertical deflection module :
Side view
Top view
Top view
Side view
Push
Connectors for the vertical
deflection module
Vertical scan switch
FRONT - TABLE
REAR - TABLE
REAR - CEILING
FRONT - CEILING
Vertical scan
switch
Horizontal
scan switches
Vertical Scan Switch
One vertical switch is used for the three CRT's. See position
of the switch (diagrams) for the corresponding projector
configuration.
To set the vertical scan switch :
• Remove the vertical deflection module (the third module
Vertical deflection module
- Press the module lock and lift up the module handle;
- Repeat this action on both sides of the module and
extract the
module out of the main frame.
• Toggle the vertical scan inversion switch to the correct
position.
• Reinstall the vertical deflection module.
Positions of the scan switches for the different mounting
configurations are illustrated on the right side.
After setting the scan switches, close the metal protection
plate and secure it with the retaining screws.
Close the top cover and reconnect the power cord to the wall
outlet.
Note : Switching over from Floor to Ceiling or vice versa
requires a complete readjustment of picture geometry and
convergence.
