SOURCE CONNECTIONS
PV152
1-13
PRO1200 SOURCE CONNECTION
Connecting a S-Video (or Composite Video) source to
Port 2
Separate Y-luma/C-chroma signals for higher quality play-
back of Super VHS signals can be connected to Port 2 . The
composite video can also be connected to this port.
To select the S-video input :
Press the
numeric button 2
on the RCU or the local keypad
.
In case of using Port 2 for connecting the Composite Video,
the selection of this source have to be done inside the
"Picture Tuning" menu. Please refer to the Owner's Manual of
this projector.
75 W Termination Switch for S-video
Terminate the S-video input of the projector using the 75
W switch next to the S-video input when the projector
operates alone or when the projector is the last unit in a
loop-through configuration.
The switch is set to "ON" :
signal terminated.
The switch is set to "OFF" :
signal not terminated.
Connecting a RGB Analog source to Port 3
Connect a RGB Analog signal via an interface (e.g. RGB
120MHz interface to Port 3: RGB analog input with auto-
matic sync detection (Separate H and V sync inputs, with
composite sync input or with sync signals on green).
Pin configuration of the D9 (male) connector of the Analog
input :
1
not connected
2
ground RGBS
3
RED
4
GREEN
5
BLUE
6
ground RGBS
7
ground RGBS
8
Horizontal /composite sync
9
Vertical sync
To select the RGB analog Input :
Press the
numeric button 3
on the RCU or the local keypad
.
Locations of the Termination Resistors and Switches
on the RGB Input Auto Sync Tracking Module
When changing a switch position or removing a resistor,
turn off the projector and unplug the power cord from the
wall outlet.
S1 Force Negative Sync
(ON=yes)
R81
Hsync
R101
Vsync
R41
(Blue)
R21
(Green)
R1
(Red)
S2 Blue in Green (ON=yes)
Line termination 75
Ω
resistors
75
Ω
Termination Switch
1
2
3
4
4 pin connector configurations:
For S-video:
Pin 1: earth(ground) luminance
Pin 2: earth(ground) chrominance
Pin 3: luminance signal(Y)
1Vpp
±
3dB
Pin 4: chrominance signal(C)
300mVpp
±
3dB
For video:
Pin 1: earth(ground) video
Pin 2: not connected
Pin 3: video signal
Pin 4: not connected
O N
OFF
POWER / MAINS
800 peripherals
R
G
B
Comp-/H-SyncV-Sync
COMM. PORT
PORT 3
P O R T 4 / 5
V-nom
I-nom
Freq
See installation instructions before connecting to the supply.
Voir la notice d'installation avant de raccorder au réseau.
120/230 V
7/5 Amp
50/60 Hz
S-VIDEO
OFF - ON
75 Ohm
VIDEO
green : operation
red : standby
PORT 2
PORT 1
OFF - ON
75 Ohm
PROJECTOR MODE
inver.
75 ohm term.
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any interference received
including interference that may cause
undesired operation"
RGB 120MHz interface
