![background image](http://html1.mh-extra.com/html/zeiss/opmi-visu-160/opmi-visu-160_instructions-for-use-manual_3451070198.webp)
198
Maintenance / Further information
G-30-1529-en
OPMI® VISU 160 on S8, S81 & S88 Suspension Systems
Issue 5.0
Printed on 09. 10. 2006
Changing the Superlux Eye xenon lamp module
Warning!
The lamp module must only be changed by appropriately trained per-
sonnel.
Improper handling of the xenon lamp may lead to damage or injury.
Please observe the following points:
•
First switch off the suspension system at the power switch.
•
Only change the lamp module after it has cooled down completely! In
the event of a malfunction, there is a risk of explosion due to the high
pressure inside the lamp. The hot surface of the xenon lamp may also
cause burns.
•
Only change the module after switching off the system. The igniter
produces high voltage when the system is on.
•
Press button (1). The lamp module is slightly ejected.
•
Pull out the lamp module as far as it will go.
•
Slide the original transport case (2) over the module, making sure that
bolt (3) engages in bore (4). This unlocks the stop.
•
Remove the old module and install the new lamp module by proceed-
ing in the reverse order.
•
Check the function of the xenon lamp and backup xenon lamp.
Pack the old lamp module (5) in the transport package of the new lamp
module. Fill in the enclosed return card and send the old lamp module to
the nearest Carl Zeiss service agency.
Note:
•
Only use the original transport case (2) as it also provides explosion
protection, should xenon lamps be defective.