Zeiss Axio Scope.A1, Operating Manual

Page: 10 / 123

INTRODUCTION
Carl Zeiss Safety Guidelines Axio Scope.A1
10
M60-2-0007 e 05/08
The microscope Axio Scope.A1 and its genuine accessories may only be used for microscopy methods as
indicated in this manual.
The following guidelines are especially important:
The manufacturer admits no liability if the microscope, its components or single parts, are used
in any different manner. Liability is also excluded for any service or repair work performed by
non-authorized personnel and any rights to claims under guarantee expire.
The microscope may only be plugged into an electrical outlet equipped with a safety contact.
The safety aspect must not be disabled by using an extension cord which does not have a
ground wire.
Whenever it becomes apparent that any of the safety mechanisms is out of order, the
microscope must be switched off and protected from any accidental use. Please contact the
Zeiss Service Department or the Carl Zeiss Microscopy Service before switching the microscope
on again.
The lower stand parts for LED illumination and those with integrated HAL 50 illumination are
equipped with a power supply unit integrated in the stand. This unit adapts to a voltage range
of 100 to 240 V ±10 %, 50 / 60 Hz, no further voltage adjustment is necessary on the
microscope itself.
The auxiliary power supply unit SNT 12 V DC 100 W for HAL 100 covers a voltage range from
100 to 240 V AC
±
10 %, 50 to 60 Hz. It adapts automatically to the applied voltage.
The transformers for the HBO 100 adapt to a voltage range from 100 to 240 V AC, 50 to
60 Hz. They adapt automatically to the applied voltage. No further voltage adjustment is
necessary.
However, the transformer for the HBO 50 must be adjusted according to the applied voltage
(100, 110, 120, 127 or 230, 240 V). Please do not forget to adjust the power frequency
accordingly (50 or 60 Hz).
Before you switch on the microscope, please verify that the voltage you are about to use is
suitable.
Always pull the plug before you open the microscope or change a fuse!
Please make sure that the fuses are suitable for the applied nominal current. Never use any
makeshift fuses and do not short-circuit the fuse holders.
The microscopes Axio Scope.A1 do not have any special safety fixtures to protect from acid,
potentially infectious, toxic, radioactive or other specimens potentially hazardous to your health.
All legal requirements, especially the national regulations for the prevention of accidents must
be followed.