ENGLISH
Z21 XL BOOSTER
33
The connecting tracks are connected to the booster via the enclosed plug-in terminal. Use cable cross
sections of at least 1.5 mm² for the feed. In case of longer track sections, please feed in at several points.
If the current consumption exceeds 5 A permanently, the section is overloaded and must be divided (an
additional booster is needed). This leaves a small reserve to be able to safely switch turnouts or the like.
INFO:
Make sure that the feeder tracks do not contain capacitors (often needed for analogue
operation).
Connection at the Track
Attention:
When using older, non-RailCom-capable units at the same time, in the case of com
-
mon disconnect points it must be observed: if the RailCom cutout is generated in one section
but not in the neighboring section, micro short-circuits would occur when crossing the common
disconnection point. Therefore, the RailCom of the
Z21 XL BOOSTER
must be deactivated for
such setups (see chapter "STOP Button and Configuration").
Booster Section 1
separate both sides
separate both sides
Booster Section 2
Z21 XL Series
Separation point
Track signal without RailCom
Track signal with RailCom
RailCom Cutout
RailCom
channel 1
RailCom
channel 1
10870 Z21 XL Series Central
10869 Z21 XL BOOSTER
mit RailCom (adjustable)
Central
Booster
without RailCom
Summary of Contents for XL BOOSTER
Page 23: ...23 DEUTSCH Z21 XL BOOSTER ...
Page 45: ...ENGLISH Z21 XL BOOSTER 45 ...
Page 67: ...FRANÇAIS Z21 XL BOOSTER 67 ...
