![background image](http://html2.mh-extra.com/html/yuchai/u35/u35_operators-manual_4668496095.webp)
4-26
5. Lifting the machine
A. Safety Precautions
1) Do not lift the machine when there are people on it.
2) Ensure that the steel wire rope used for lifting the machine has sufficient strength to
withstand the weight of the machine.
3) Do not lift the machine in any position other than the one provided in the following
procedure, as there is a risk of the machine losing its balance.
4) Do not lift the machine with the upper structure turning to the side. Before hoisting, turn
the working device to one end of the sprocket and make the lower track parallel to the upper
structure.
5) When lifting, keep the machine level.
6) It is very dangerous to walk under the machine when lifting it. Do not walk under the lifted
machine.
B. Lifting procedures - machines with standard technical specifications
Attention: The lifting procedures are applicable to standard technical specifications.
According to the accessories and options actually installed, the hoisting method will
be different due to different dimensions, weight, center of gravity distribution, etc.
When hoisting the machine, make
operations on the flat ground by following the
below steps.
1) Turn the upper structure so that the
working device is at one end of the sprocket.
2) Fully extend the bucket cylinder and stick
cylinder, and then use the boom cylinder to
drop the working device to the ground, as
shown on the right.
3) Turn off the engine, make sure there is
nothing around the cab, and then leave the
machine. Close the cab doors and windows.
4) Put a wire rope between the guide wheel
and the track thrust wheel from the front, and
between the drive wheel and the track thrust
wheel from the back. It is also possible to
thread the wire rope from under the tracks.
5) Adjust the lifting angle of the wire rope to
30° to 40°, and then slowly hoist the
machine.
6) After the machine leaves the ground,
carefully check whether the machine is
balanced, and then slowly hoist it.
Summary of Contents for U35
