![background image](http://html2.mh-extra.com/html/yuchai/u35/u35_operators-manual_4668496119.webp)
5-16
1) Turn off the engine, open the drain
valve by hands, turn the valve
counterclockwise for about three and a
half turns, until the valve drops at 25.4 mm
(1 in) and begins to drain;
2) Drain the water from the separator until
the clean fuel is visible.
3) To close the valve Turn the valve
clockwise until it is tightened by hands.
Note: Do not overtighten the drain
valve when closing it. Overtightening
will damage the thread.
Turn the valve
counterclockwise
Valve
lowering
Turn
clockwise
7. Replace the oil filter element
Replace the filter element every 200 hours
or 3 months. Make sure to use genuine
filter element.
1) Remove the fuel filter;
2) Clean the gasket surface of the filter
seat with a lint free cloth;
3) Discard the O-ring;
4) Install a new O-ring;
Note: Check whether there is an old
seal on the filter element seat. It will
cause oil leakage if the old seal is
stuck on it.
5) Fill up the new filter with clean fuel, and
lubricate the O-ring with clean engine oil;
6) Install the fuel filter as specified by the
filter manufacturer.
Note: To reduce the possibility of fuel
leakage, ensure that the fuel filter is
installed firmly but not too tightly.
Excessive mechanical tightening will
damage the fuel filter.
7) After replacing the filter element, start
the engine and check the sealing surface
of the filter element for oil leakage.
Engine cooling system
Maintenance instructions
Summary of Contents for U35
