![background image](http://html2.mh-extra.com/html/yuchai/u35/u35_operators-manual_4668496030.webp)
2-16
5) Do not turn on slopes or cross slopes.
Be sure to go down to a flat area and
change the position of the machine before
climbing up the slope.
6) When working on a slope, it is
necessary to start from a high place and
gradually excavate towards the downhill
direction, with the dozer blade at the back
and pressing against the ground, and the
unloading position is in the uphill direction.
7) Travel at low speed on grass, fallen leaves, or wet steel plates, as even on small slopes,
there is a risk of machine slipping.
8) It is strictly prohibited to make sharp turns when going uphill or downhill, otherwise the
machine may tip over.
9) When stopping on a slope, the front dozer blade must be lowered and inserted into the
soil. Only after it has stopped steadily can the engine be stopped and the driver be allowed
to get off.
Danger
Stopping on a slope is very dangerous! If it is
unavoidable, the following must be followed: if
the engine stalls on a slope, immediately lower
the bulldozing blade and bucket to the ground,
and place all handles in the neutral position,
and then restart the engine. Even if the
machine is stopped for a short time on a slope,
the bucket and dozer blade should be lowered
to the ground, and all levers should be pulled
to the center position. At the same time,
sufficient obstacles should be placed at the
lower end of the track for securing.
Summary of Contents for U35
