![background image](http://html2.mh-extra.com/html/yuchai/u35/u35_operators-manual_4668496077.webp)
4-8
Movement of the machine
1. Safety rules for moving the machine
1) Before starting the excavator, it is required to be familiar with the surrounding
environment of the site, whether there are pedestrians, obstacles, ground bearing capacity,
etc.
2) Before starting the excavator, the horn should be sounded to alert the people nearby to
pay attention.
3) It is strictly prohibited for the driver to start and operate the machine while standing on the
ground.
4) The excavator must travel and operate on solid ground that is over 1.5 times of its width.
5) When traveling through areas such as underground passages, bridges, or high-voltage
power lines, it is necessary to ensure command by a specially designated personnel.
6) When traveling, it is necessary to lower the boom and bucket arm to maintain the optimal
position of the center of gravity.
7) When the machine is moving, only the driver is allowed to drive on the machine and no
passenger is allowed on the machine.
8) Before operating the steering joystick, check the direction of the track frame.
9) If the dozer blade is in the rear side, the operation of the travel joystick is reversed.
10) No one is allowed in the area around the machine.
11) Clear all obstacles on the travel route of the machine.
12) The rear of the machine is a blind spot, so special attention should be paid for reverse
traveling.
Warning: Sudden switching of the joystick during high-speed traveling can
be dangerous.
1) Do not suddenly switch the joystick, otherwise it may cause sudden start.
2) Avoid sudden switching of the joystick from forward to reverse (or from
reverse to forward).
3) Avoid sudden changes in the joystick, such as sudden stops from high
speed (releasing the joystick).
2. Preparation for moving the
machine
1) Lower the left flip box.
2) Turn the accelerator lever to the high speed
position to increase the engine speed.
Summary of Contents for U35
