![background image](http://html2.mh-extra.com/html/yuchai/u35/u35_operators-manual_4668496029.webp)
2-15
4) During traveling or operating, it is important to maintain a safe distance from people,
buildings, or other machines to avoid contact.
5)When traveling through height-restricted areas such as underground passages, bridges,
or power lines, it is necessary to ensure command by a specially designated personnel. In
addition, a safety distance must be kept.
6) Be sure to lock the platform when going uphill or downhill.
7) When passing across bridges, buildings, or supports, it is necessary to first confirm
whether they are sufficient to support the weight of the machine.
8) If it needs to drive on the highway, first consult the local traffic management department
and obtain permission before starting traveling on the road.
3. Traveling or working on slopes
It is extremely dangerous for traveling and
operating the excavator on slopes, therefore,
special care must be taken in this case.
1) It is not recommended climbing or
descending on long slopes greater than 20
degrees.
2) The operator shall fasten the seat belt
when the machine is in operation, especially
on slopes and in hazardous areas.
3) When the excavator is moving uphill, the
drive wheel should be in the downhill
direction, the boom and stick are fully
extended parallel to the slope, the bucket
teeth are 20-30cm away from the ground,
and the platform is locked. Then go uphill at
a low speed.
4) When the excavator is moving downhill,
the platform should be locked, the drive
wheel should be in the uphill direction, the
boom and stick are fully extended, the
bucket teeth are 20-30 cm away from the
ground. Go downhill at low speed.
Summary of Contents for U35
