![background image](http://html2.mh-extra.com/html/yuchai/u35/u35_operators-manual_4668496124.webp)
5-21
3) Clean the drain plug and reinstall it. If
the seal ring is damaged, replace it.
4) Open the oil filler port.
5) Refill with new oil until the oil reaches
the "Maximum" mark H on the oil dipstick.
6) Cover the oil filler cap and allow the
engine to idle for 5 minutes.
7) Check the oil level 10-20 minutes after
the engine is stopped. Refill oil as
necessary.
3. Replace the engine oil filter element
The new machine shall be cleaned for the
first time after 50 hours of operation, and
every 500 hours thereafter.
Replace oil filter
1) Clean the area around the filter seat,
remove the oil filter, and clean the sealing
gasket surface on the filter seat;
2) The oil filter has two gaskets, which are
lubricated;
3) Before installing the filter, apply a layer
of engine oil on the surface of the sealing
gasket;
4) Install the oil fuel filter as specified by
the oil filter manufacturer.
5) Run the engine at low idle speed and
check whether the oil filter leaks;
6) Shut down the engine and wait for 15
minutes to allow the oil in the engine parts
to fully flow back;
7) Check the oil level and, and add oil to
the maximum mark "H" on the oil dipstick
if necessary.
Oil filler port
Oil dipstick
Oil filter
Summary of Contents for U35
