www.youfibercable.com
Email:[email protected] MSN:[email protected]
16
Working mode
Automation or manual optionally
Maintenance
Enter the next maintenance menu
7.1
Heating time
The setting range of heating time is 1-60s, step-size is 1S. If heat time is 4, actual
heat time is 4S. Press “HEAT” to turn on the light, then the heater begins to work;
heater will stop working if time is up. But if the temperature were the highest value, it
would keep the temperature regularly.
Remark: Press “HEAT” to stop heating. Next heat time counts from zero.
7.2
Setting end-surface
Setting end-surface stands for the maximum cleaved angle under auto
work mode. Its setting range is 1
～16,
step-size is 0.5~
8.0
°
, it
is 6 (3.0
°)
usually. If the fiber’s cleaved angle is unqualified, the splicer will stop
working and demand to do over the end-face.
7.3
Tension Test
You can select TENSION TEST start or close, “1” means open this function, “2”
means close this function. When tension test opened, machine will do this function
automatically after each splicing.
7.4 Splicing fiber and fusion program
The two parameters can concert each other. You can select 20 kinds different
fusion program (SMF: 100 MMF: 100).
7.4.1
Splicing fiber
Figure 1 stands for selecting SM fiber and figure 2 stands for selecting MM fiber.
7.4.2
Fusion program
It stands for the adopted fusion program currently.
The program number is 1
～100,
inside it is divided to
SM1
～100 and
MM1
～100
. No.1
～
No.5 are set by
factory; you can set program from No.6
～
No.100
freely. But KL-280will adjust No.6 program after
fusion testing automatically, and setup the No.6
program, please consult 8.3-arc test. Press “ENT”
to enter the program setting menu after selecting program
number as right picture.
Cursor “
→
”
point to the optional or modifiable content,
press “▲” or “▼” to move the cursor; The next line’s number is
value of the item, press “◄” or “►” to modify; The modification
quantity in the bottom of menu stands for the change quantity of
increase/decrease key, you can press “AUTO” to select among “1,10,100”;
Press “ENT” to confirm or enter next menu;
Press “MENU” to exit current menu.
Remark: You must press “ENT” to confirm after modifying the value.
The explanations of parameters are as follows:
7.4.2.1 Pre-fusion current and Pre-fusion time
After setting gap and adjusting, KL-280 agains to work. In the process, the fusion
2008-10-10 10:55
PREARC POWER (0.1mA)
60
PREARC TIME (10mS)
11
ARC POWER (0.1mA)
90
ARC TIME (0.1S)
15
FORWORD SPEED (1ms)
5
FORWARD (1
μ
m)
11