www.youfibercable.com
Email:[email protected] MSN:[email protected]
12
Table 2
Graphic
(X axis or Y axis)
Message
Reason
Measure
Reload the fiber
1.
The bare fiber is
cleaved too long
or too short.
1.
Reload fiber.
2.
Recut fiber.
3.
Clean the lens.
Bad left fiber or
bad right fiber
Bad end-surface’s
quality.
1.
Remake the end-surface.
2.
Reset end-surface’s angle
The picture is clear
in only one direction
or picture are unclear
in two directions.
1.
There is dust in
V-groove.
2.
There is dust on
bare fiber.
1.
Clean V-groove.
2.
Clean bare fiber
3.
Reload fiber
6.3.4
Auto fusion and estimating loss
The steps of auto-fusion are as follows:
1)
Check and confirm the right option of “fusion fiber”.
2)
Consult 6.2.4 and make the end-surface of fiber.
3)
Open the windshield and fiber holder to load fiber.
4)
Close the windshield, then press “RUN”, KL-280 begin to work automatically:
clean fibers automatically, check end-surface, setup gap, adjust fiber’s core, arc
splice, estimate loss and display loss on screen.
09-03-10 15:30
AUTO (SM)
Estibate Loss: 0.01dB