Installation
___________________________________________________________________________________
___________________________________________________________________________________
- 274 -
7. Pipeline installations
7.1) Pipeline facture
7.1.1 The material of the pipeline
Standard: lubricity inside; small friction resistance; not absorbing moisture; incombustibility;
erosion resistance; longevity; lightness; good sealing; no accumulation; easily cleaning. Normally,
we can select galvanization steel, aluminum, and plastic. For short pipeline, we can also select
aluminum foil board.
7.1.2 The process of the piping
The process of the piping should meet the requirements of the design. The process can be
done in subsection. And every subsection’s length is about between 1.8m and 4m. In order to
improve the pipeline’s rigid, a rib often be added at the outer surface. The pipeline usually
adopts the flange to connect and add the asbestos washer with thickness 3mm to prevent air
leakage. At present, the sealant and adhesive tape are also used to seal.
7.1.3 The shape of the pipeline
7.1.3.1 Type of the pipeline
The pipeline has ground and directs shape. The compare is as follows:
Ground pipeline
Square pipeline
less material, need large space, its’ bending
pipe and three-way pipe need long distance
need small space, can be equipped easily, adopt
direct pipeline with the rate below 2.5 between
length and width
7.1.3.2 Specification of the pipeline
Ground pipeline should first adopt the basic series; the ratio of the long side and the short
side of the direct pipeline should not be larger than 4:1. Pipeline should be outer diameter or
outer border. Brick and concrete pipeline should be inner diameter or inner border.
Pipeline diameter
Basic series
Accessorial
series
Basic series
Accessorial
series
Basic series
Accessorial
series
100 80/90/100
300 300/320 900
850/900
120 110/120
360 340/360 1000
950/1000
140 130/140
400 380/400 1120
1060/1120
160 150/160
450 420/450
1250 1180/1250
180 170/180
500 480/500 1400
1320/1400
200 190/200
560 530/560 1600
1500/1600
220 210/220
630 600/630
1800
1700/1800
250 240/250
700 670/700 2000
1900/2000
280 260/280
800 750/800
7.1.4 The thickness of the pipeline
Summary of Contents for R-410A
