YOKOGAWA UPM100, User Manual

Page: 32 / 104

3-18
IM 77C01H01-10EN
3.4 Other Settings
3.4.6 LEAD Reactive Energy Writing
Note
A LEAD reactive energy value can be written to the UPM100 with the optional reactive power/
reactive energy measuring function.
[Procedure]
1. Write a LEAD reactive energy value to the two D registers in the table below. The data
type is integer.
2. After writing that value, write “1” to the write status register, D0094.
D Register Reference No. H No. Description Effective Range
D0089 40089 0058
Set LEAD reactive energy
value (lower 2 bytes)
Refer to the “Note” below.
D0090 40090 0059
Set LEAD reactive energy
value (upper 2 bytes)
D0094 40094 005D
Set reactive energy value
write status
If other than 1: Invalid
If 1: Writing is executed
[Example]
To set the LEAD reactive energy value to 12345:
For station number 01, use PC link communication (without checksum) and the random write
command as shown below:
If 12345 is converted into a hexadecimal value, the value is 0000 3039. Then the order of
the upper two bytes and the lower two bytes is reversed → 3039 0000.
[Command]
[STX] 01010WRW03D0089, 3039, D0090, 0000, D0094, 0001 [ETX] [CR]
[Response]
[STX] 0101OK [ETX] [CR]
Note
The set LEAD reactive energy value range of the UPM100 with the integral resolution (kWh) option
changes depending on the values of the VT and CT ratios. The table below shows the set value
range.
[Secondary Rated Power] x [VT Ratio] x [CT Ratio] Possible Set Value Range
Below 1 Mvar 0 to 99999 kvarh
1 Mvar to 10 Mvar 0.00 to 999.999 Mvarh
10 Mvar or above 0.0 to 9999.999 Mvarh
Regardless of the value of [Secondary rated power] x [VT ratio] x [CT ratio], the set LEAD
reactive energy value range of the UPM100 with the integral resolution (Wh) option can be
set within the range below:
Possible set value range: 0 to 9999999 varh
Note
The secondary rated power of the UPM100 changes depending on its model and suffix codes.