Functions
1-3
IM 755601-01E
1
1.2 Functions
Handler Interface Function
The handler interface is used to output comparator results, contact check results, index
signals, and various other signals.
For the specifications of each pin, see section 12.7 “Handler Interface Specifications.”
Other Functions
Storing/Recalling Measured Data
Up to 2000 data sets can be stored. Each data set contains the measured value
obtained from each measurement.
A data set is stored or recalled at every trigger occurrence.
Initializing settings
The settings can be reset to factory default values or initial values.
Measurement Mode/SETUP mode
The instrument has two modes, measurement and SETUP modes. You can switch
between the modes as necessary.
Measurement mode: This mode measures and displays the resistance. Only the R/%
key, SETUP/MEAS key (SHIFT+R/% key), and STORE DATA
key (SHIFT+0 key) are enabled. Since all other keys are locked,
an erroneous operation resulting from pressing the wrong keys
can be avoided.
However, the TRIG key is enabled when the trigger mode is set
to [MANUAL] and the RECALL DATA key is enabled when
recalling data.
SETUP mode:
This mode is used to change the instrument’s settings. No
measurements can be made in this mode.
Limit Mode (Deviation/Absolute)
You can select whether to use a deviation (%) or an absolute value (R) to specify the
limit value (LO, HI) that is used when determining the result with the comparator function.
The comparator determines the result using deviation (%) if you set the limit mode to
deviation. The measured value can then be displayed using % or
Ω
.
The comparator determines the result using absolute value (R) if you set the limit mode
to absolute mode (R). The measured value is displayed using
Ω
. In this mode, the
comparator function works only for the 1
Ω
range.
