YOKOGAWA 7556, User Manual

Page: 102 / 139

10-28
IM 755601-01E
Example
:RECALL:RESULT? LIMIT
→
PCNT,1.0000E+05,5.00, —5.00
:RECALL:RESULT? COUNT
→
1971,14,8,7
:RECALL:RESULT? STATISTICS
→
1990,10,
0.02,—0.02,0.02,
0.02,0.002,0.102
Description • If the parameter is omitted, it is equivalent to
specifying STATistics.
• A query cannot be made if there are no
measured data that are stored. Doing so will
result in an error (830).
• This query cannot be made in the
measurement mode. Doing so will result in
an error (800).
• Statistical computation is performed on the
communication output data (5.5 digits).
:RECall[:STATe]
Function Sets the measured data recall state (ON/OFF)
or queries the current setting.
Syntax
:RECall[:STATe] {<Boolean>}
:RECall:STATe?
Response
{1|0}
Example
:RECALL:STATE ON
:RECALL:STATE?
→
:RECALL:STATE 1
Description • Executing the “
:RECall[:STATe] ON
” command
sets the instrument in a recall start ready state.
The actual recall operation is not executed at this
point. Measured data are recalled from the
memory every time a trigger occurs after the
instrument is switched to the measurement
mode using the “
:MEASure ON
” command.
• When the last data point is recalled, the
“
:RECall[:STATe]
” is automatically turned OFF.
Executing the “
:RECall[:STATe] OFF
”
command will forcibly terminate the recall
operation.
• When there are no measured data stored in the
memory, “
:RECall[:STATe]
” cannot be turned
ON. This will result in an error (830).
• If the “
:STORe[:STATe]
” is turned ON,
“
:RECall[:STATe]
” cannot be turned ON.
Attempting to do so will result in an error (832).
10.2.14 SELFtest Group
The commands in the SELFtest Group deal with the self test function. These commands can be used to make the
same settings and inquiries as the “tESt” menu accessible through the MISC key on the front panel.
:SELFtest : KEY
LED
HANDler
;
10.2 Commands
:SELFtest:KEY
Function Executes the panel key test.
Syntax
:SELFtest:KEY
Example
:SELFTEST:KEY
Description For the test description, see page 11-6.
:SELFtest:LED
Function Executes the LED test.
Syntax
:SELFtest:LED
Example
:SELFTEST:LED
Description For the test description, see page 11-6.
:SELFtest:HANDler
Function Executes the handler interface output test.
Syntax
:SELFtest:HANDler
Example
:SELFTEST:HANDLER
Description For the test description, see page 11-6.