Yamato FP102, Instruction Manual

Page: 10 / 75

7
2. Before operating the Equipment
Precautions when installing the Equipment
5. Ventilate sufficiently for the Equipment
Do not operate the Equipment blocked in the radiating slit holes-Louver on its side and back
panels and top panel. Refer to 3. “Name and Functions of each part” on page 10 for the location
of Louvers.
Internal temperature will rise, causing a malfunction of the controller to compromise the
performance as well as to cause a possible accident or a fire.
6. Do not operate at the location of liquid splashing.
Do not operate this Equipment at the location of liquid splashing. If this Equipment will be wetted
by splashing any kind of liquid, it may cause accident, electrical shock and/or fire.
7. Never operate in an atmosphere where flammable or explosive gas is present.
Never operate this Equipment in an atmosphere where flammable or explosive gas is present.
This Equipment is not explosion-proof. Spark may be discharged by switching Earth Leakage
Breaker (ELB) “ON(
｜
)
” and “OFF(
○
)
” and also relay during operation, and then it may cause
fire
or explosion. See Chapter 13. “List of Dangerous Substances” for flammable and explosive
gases on page .69
8. Connect Power Cord/Power Cable to receptacle or switch board of facilities.
Connect Power Cord/Power Cable to suitable receptacle/switch board of facilities according to
electrical requirements as follows.
Electrical
requirements:
FP102 AC115V single phase 50/60Hz 10A or more (ELB capacity; 15A)
FP302 AC115V single phase 50/60Hz 21.5A or more (ELB capacity; 30A)
FP312 AC220V single phase 50/60Hz 13A or more (ELB capacity; 15A)
FP412 AC220V single phase 50/60Hz 18A or more (ELB capacity; 20A)
The operational voltage range is
±
10%, the voltage range where the specified performance is
guaranteed is rating
±
5%, the frequency is rating
±
1%.
※
Check line voltage of its receptacle/switch board of facilities and/or whether utilize the same line
with other equipments or not, if this Equipment does not start up/operate even to turn Earth
Leakage Breaker (ELB) On (
｜
). Take correct action for the solution, such as changing its
power source away from other equipment.
※
The length of the power cord outside the unit is about 2
ｍ
.
9. Take care for handling of the power cord.
・
Never operate this Equipment at bundled Power Cord/Power Cable. May heat its Cord/Cable
and then cause fire, if operate at bundled it.
・
Do not modify, bend forcibly, twist or pull Power Cord/Power Cable. Otherwise, may cause
fire and/or electrical shock.
・
Do not connect too many wires to a branching tap or extend wires using a cord reel.
Otherwise, heat is generated or a fire may result. Also, the voltage may drop or temperature
control performance may be compromised.
・
Do not damage Power Cord/Power Cable by setting under any desk and/or chairs, or by
pinching it between objects. Otherwise, may cause fire and/or electrical shock.
・
Do not place Power Cord/Power Cable close to kerosene heater, electric heater, or other
heat-generating devices.
・
Turn immediately off Earth Leakage Breaker (ELB) and also disconnect Power Plug/breaker
of switch board of facilities, if it is damaged such as exposure of core wire or disconnection.
May cause fire or electrical shock, if this Equipment is operated with damaged Power
Cord/Power Cable.
・
Connect Power Cord/Power Cable to appropriate receptacle or switch board of facilities.