Yamaha RX10RL, Owner'S Manual

Page: 66 / 99

8-13
8. Install the engine oil drain bolts, and then tighten
them to the specified torques.
9. Add 2.0 L (1.8 Imp qt, 2.1 US qt) of the recom-
mended engine oil to the oil tank, and then install and
tighten the oil level gauge/dipstick.
10. Start the engine, warm it up for several minutes, and
then turn it off.
11. Add sufficient oil of the recommended type to raise it
to the “F” level mark on the oil level gauge/dipstick.
(See pages 6-3–6-4 for the checking procedures.)
CAUTION:
@
●
When adding the engine oil, be careful not to fill
above the “F” level mark on the oil level gauge/
dipstick.
●
Make sure that no foreign material enters the
engine oil tank.
@
12. Start the engine, and then let it idle for several min-
utes while checking it for oil leakage. If oil is leaking,
immediately turn the engine off and make sure that
the engine oil drain bolts and oil level gauge/dipstick
are installed correctly.
13. Turn the engine off, and then connect the oil level
gauge coupler.
Tightening torques:
Crankcase engine oil drain bolt:
30 Nm (2.6 m·kgf, 3.2 ft·lb)
Oil tank engine oil drain bolt:
16 Nm (1.6 m·kgf, 11 ft·lb)
Recommended engine oil:
See page 6-2.
Oil quantity:
With oil filter cartridge replacement:
3.0 L (2.6 Imp qt, 3.2 US qt)
Without oil filter cartridge replacement:
2.8 L (2.5 Imp qt, 3.0 US qt)
Total amount:
3.8 L (3.3 Imp qt, 4.0 US qt)
U8FP10.book Page 13 Thursday, April 28, 2005 5:11 PM