RM1x SEQUENCE REMIXER
85
PA
TTERN MODE
3. Set all
Use this parameter if you want to set the velocities of
all targeted notes to the same fixed value (1 to 127). If
you do not want to use this feature (if you want to make
the linear adjustment instead), set the value to Off.
Note that if the setting is other than Off, the Rate and
Offset values are ignored.
■
Settings : Off (0), 001 ... 127
4. Rate
The Rate parameter applies a proportional change to
the velocities of all targeted notes. A setting of 100%
produces no change; a setting of 50% cuts the veloci-
ties in half; a setting of 200% causes the velocities to
double.
■
Settings : 000% ... 100% ... 200%
Original velocities
Rate = 50%
(Vel)
96
64
32
127
96
Rate = 150%
(Vel)
127
96
48
127
127
(Vel)
48
32
16
63
48
5. Offset
This parameter adds a fixed value to each of the Rate-
adjusted velocity values. A setting of 0 produces no
change. Positive values increase the velocity, while
negative values decrease it.
■
Settings : -99 ... +00 ... +99
Original velocities
Offset = -20
(Vel)
96
64
32
127
96
Offset = +20
(Vel)
116
84
52
127
116
(Vel)
76
44
12
107
76
Job 03 Modify Gate Time
1
3
2
4
5
This job alters the gate times of the specified range of notes
(pitches) in the specified segment of the designated track. The
gate time refers to the length of time that a note is held. For
non-percussive voices, the gate time is equal to the actual play-
back time span.
Using this job, you can choose to change all targeted notes to
some fixed gate time, or you can apply a relative (linear) ad-
justment to the original gate times.
If making a relative adjustment, you use two parameters: the
Rate and the Offset. The Rate value applies a proportional
change to the gate time, while the Offset value (which is ap-
plied after the Rate adjustment) adds a fixed value. The rela-
tion is as follows:
Adjusted gate time
= (original gate time X Rate) + Offset.
If the adjustment result is less than 1, the RM1x sets the value
to 1.
12. Job
