Yamaha RM1x, Owner'S Manual

Page: 61 / 154

RM1x SEQUENCE REMIXER
61
PA
TTERN MODE
5. MIDI delay
❏ Feedback
Track number
Transpose
Recording the MIDI delay Settings
The MIDI delay settings can actually be merged into the se-
quence data as follows.
1
Make the MIDI delay settings as described above.
2
Press the [PATTERN] button to go to the Pattern play-
back mode.
3
Press the REC
e
button to engage the record
standby mode.
4
Set the REC TYPE parameter to “OVERDUB.”
5
Press the PLAY
p
button to begin recording. You
don’t actually need to record any new data; the MIDI
delay setting will automatically be recorded.
6
Press the STOP
s
button to stop recording after
the pattern has played through once. The MIDI delay
level setting will automatically be set to 0 when re-
cording is stopped.
Parameter Values Function
Feedback velocity -127 ... 000 ... +127 Offsets the velocity of the delayed notes, thereby affecting the level
of the delay sound.
By offsetting the feedback velocity of the delayed note, this param-
eter affects the level of the delay sound and how the repeats decay.
Positive values produce increasing repeat level, while negative val-
ues produce decreasing repeat level.
Feedback note -24 ... 00 ... +24, RND Offsets the pitch of the delayed notes so that each repeat will have
a different pitch. By setting an appropriate FB NOTE value it is pos-
sible to produce delays that sound like glissandos or even arpeg-
gios. Each increment corresponds to a semitone.
The “RND” setting produces delay repeats with random pitch.
Feedback gate time -100 ... 000 ... +100 Offsets the gate time of the delayed notes by the specified percent-
age so the repeated notes become longer or shorter. Positive set-
tings produce gradually longer repeated notes, while negative set-
tings have the opposite effect.
Feedback clock -100 ... 000 ... +100 Offsets the timing of the delayed notes in clock increments. Positive
settings result in an increasingly longer delay time from repeat to
repeat, while negative settings have the opposite effect.
Track number 01 ... 16 Shows the current selected track number. Track number selection
can be accomplished via this parameter, or by the keyboard method
described on page 27.
Transpose -36 ... +36 Shows the current transpose value. Transposition can be accom-
plished via this parameter, or by the keyboard method described on
page 27.
* For information about how to change values, refer to the Basic Operation (page26).