Instruction #1033402B - Page 2 of 12
1
2
3
4
6
5
INSTALL PADS TO ONE SET OF MOUNTS.
IF THE BOLT THREADS STILL DO NOT
EXTEND BELOW THE CLOSED BAIL:
ATTACH THE THUMB-WHEEL:
ATTACH SMALL BAIL TO BACKBONE.
PLACE THE MOUNT ONTO THE BAR, OPENING TOWARD THE FRONT OF THE CAR.
REMOVE THE FITTED MOUNT FROM THE BAR.
AREO CROSSBARS (NON ROUND OR SQUARE)
ROUND OR SQUARE CROSSBARS,
continue to step 7.
Start here to find the Universal MightyMount™
parts that fit your crossbars.
Press a pad into
the smaller bail
(marked “A”).
Use the upper hinge slot on the backbone.
Press a pad into the
backbone.(You may
need to rotate the
pad to fit correctly.)
If there is any looseness, or the mounts can slide
on the bar, follow the fitting process again.
backbone
bail
Bolt
threads
MUST
extend
below the
closed bail.
IF THE BOLT DOES NOT
EXTEND, remove the bail, and
set the end into the lower slot.
•
Close and compress the
mount around the bar.
•
Insert a short hex bolt
into the hex opening in
the barrel sleeve, and
insert into mount.
•
Use the larger bail (marked “B”)
with longer bolt.
•
Repeat step 2 and 3.
•
Assemble the remaining mounts,
and carefully set them aside.
•
Do not discard the unused parts (you
may use them on future vehicles).
•
Continue to step 9.
ALWAYS USE THE SHORT BOLT WITH SMALL BAIL — AND LONG BOLT WITH LARGE BAIL.
Always install
the pad on the
bail for this
fitting process.
Repeat the fitting
process until
the MightyMount™
conforms to the size of
your crossbars when
the wheel is tightened.
