Instruction #1033402B - Page 5 of 12
19
20
21
22
23
25
26
27
29
24
INSTALL WHEEL STRAPS.
LOAD THE BIKE.
POSITION THE BIKE.
TIGHTEN THE RED KNOB.
SECURE THE STRAPS.
RETIGHTEN STRAPS.
PULL STRAPS
THROUGH SPOKES.
INSTALL TRAY END CAPS.
Set your bicycle in the
wheel tray with the hoop
lying flat between the
wheels.
NOTE:
The front
wheel of the bicycle must
rest inside the hoop.
Unscrew red knob
and roll bicyle out
of hoop.
Slide the open wheel
straps onto the wheel
tray with the red
buttons towards you.
Pull the strap through wheel spokes
on the front and rear wheels.
Do not overtighten
the strap!
Some attachments on the down tube must be removed
if the jaws cannot attach above or below them.
(if not installed earlier)
Raise hoop and roll
bicycle forward
as jaws meet the
down tube.
Raptor Aero™ can mount above
or below most attachments,
such as waterbottles.
IN THE OPEN POSITION, JAWS SHOULD CLEAR
THE BIKE FRAME.
UNLOADING BICYCLE:
•
Insert the strap
end behind the
red tab.
•
Tighten the
strap by
repeatedly
lifting the red
tab.
•
If the wheel is still loose in the
tray slide the strap in the tray
until it rests against the rim.
•
Tighten again.
To avoid paint wear, clean
contact points on frame
before tightening the jaws.
Release the
strap by pushing
the red button.
CAUTION!
DO NOT
OVERTIGHTEN
THE RED
KNOB!
LOAD AND SECURE YOUR BIKE — (BIKE WEIGHT LIMIT IS 30 LBS.)
Do not let the strap push
against the valve stem.
28
Do not
overtighten!
BEFORE DRIVING AWAY:
•
Check the knob.
•
Check both wheel straps.
•
Tighten if necessary.
2X
