Instruction #1033402B - Page 4 of 12
ATTACH WHEEL TRAY TO HOOP ASSEMBLY
ALL AERO CROSSBARS (NON ROUND OR SQUARE):
16
•
Insert a long carriage
bolt through the
Raptor’s baseplate.
•
Add the spacer to the
Universal MightyMount™
and secure with nut.
•
Tighten with supplied
wrench.
•
Reattach the upper pad.
•
Insert baseplate bolt head 8” into slot in wheel tray.
•
Use the washers and wing nut to attach the hoop
baseplate onto this bolt.
•
Slide the wheel tray bolt into the track at the other
end of the wheel tray.
REAR
WHEEL
TRAY:
requires
the short
carriage
bolt.
Remove the upper pads
before continuing.
ON SOME
SMALLER BIKES:
If the wheel straps
need to be between
the crossbars, slide
them onto the
wheel tray now.
STANDARD BIKES:
Install wheel straps
outside the crossbars
after steps 18 or 19.
SPACER POSITIONING:
If your factory bars are angled, and the spacer is not
flat against the baseplate, loosen the carriage bolt and
rotate the spacer as needed. You will need to remove
the pad. Be sure to replace it once the bolt is tightened.
SMALLER BIKES ONLY:
Slide the open wheel
straps onto the wheel
tray with the red buttons
towards you.
Combine tray/hoop assembly with Universal MightyMounts™.
long
carriage bolt
spacer
(Raptor Aero baseplate)
nut
upper pad
17
•
Insert two baseplate bolts up through
the SnapArounds™ and baseplate.
•
Secure with elongated hex keys.
•
Insert the wheel tray bolt through the
SnapAround on the other crossbar.
•
Secure with short hex key.
Tighten all
3 hex keys
firmly onto all
SnapArounds™.
(baseplate)
SPACER
Set tray/hoop assembly onto crossbars.
ROUND OR SQUARE CROSSBARS:
18
NOTE:
Hoop must rest
horizontally on tray while turning
the hex keys. When hoop is raised
the hex keys cannot be turned.
8”
(20 cm)
