Version 1.0
PartPro150 xP Operation Manual
54
of the cartridge.
If the ID tag is missing, please contact the service center
for help.
2002
Laser module not calibrated
Contact the service center for help.
2003
Resin bottle ID tag voided
The ID tag is void when the resin bottle is empty. Please
replace the resin cartridge.
2004
Covers opened
Close the covers securely.
2005
Invalid resin tag detected
Install XYZprinting resin bottle and try again.
2006
File parsing failed
Parsing failure is caused by slicing issue or incompatible
firmware version. Re-slice the file with the slicing
software. Make sure to specify the corresponding printer
model while exporting the file.
In some case you may need to re-slice the files after
updating the software and the firmware.
2007
File size over the limit (200MB)
Select another file that is smaller than 200MB.
2008
Non-manifold issue found on the
model
Repair the file with 3D model repairing software (such as
net fabb or Make Printable) and slice the model again.
Error code in the software
Error Code
Cause
Troubleshooting
1021
Slicer not found
Reinstall the software and try again.
1022
Transmission failure due to
connection issue
Check the USB cable connection between the printer and
the computer and try again. Do not unplug the USB cable
from either side before the transmission is completed.
1023
Insufficient RAM for loading more
files
Try either method below:
Reduce the size of the model.
Add more RAM to your system.
1024
System error detected
Restart the software and try again.
1025
Unable to save the file to the
selected disk
Check the following items:
Check the connection between the selected disk and
your PC.
Check if there is sufficient disk space on the selected
disk.
1026
Non-manifold issue found in the file
Repair the file with 3D model repairing software (such as
net fabb or Make Printable) and slice the model with the
software again.
