Version 1.0
PartPro150 xP Operation Manual
51
Alcohol bath
Support removal
Sanding
Post-curing
POST-PROCESSING
Resin printed models should go through the following post-processing steps to ensure it is ready for final
application:
Protective gloves should be worn before handling printed models.
Alcohol bath
Rinse part in Alcohol (
≧
95% Alcohol). Pour alcohol into the
rinse bucket, shake the print for a few minutes, and then
rub it with your fingers thoroughly.
Support removal
Use pliers or other tools to remove the support structure
from the cleaned prints. Avoid pulling out the supports
directly, or the surface of the models may be damaged.
Sanding
If the support touch-points are visible, sand the
surface with sand paper.
Post-curing
The printed object produced with the resin must be post
cured using UV light to ensure the material is completely
polymerized to achieve the best material properties. The
suggested curing time of each material is provided in the
instructions for the beta test.
