27
Installing External Hardware Options
This section explains how to install external hardware options.
External Floppy Drive
Note
To avoid corruption, do not attach the external floppy drive with a disk
installed.
There are four screw holes on the back of the unit to mount an external floppy disk drive
(9000-EXF). Refer to Figure 3-7.
Note
Make sure the floppy drive cable is able to reach the external floppy
connector on the system before making the cutout.
Creating a Customized Logo
You may place a customized label on the unit. Figure 3-10 provides the dimensions and
recommended requirements for a customized label.
0.55 (13.97)
2.05 (52.07)
Your Logo On
Entire Surface
NOTE: All dimensions are in inches (mm)
RECOMMENDED MATERIAL: 0.007 (0.176) thick
polyester with 3M #468 adhesive on far side
0.06 (1.52)
(4 Places)
Figure 3-10. Logo Label Dimensions
Once you have created a customized label, place it over the “Xycom Automation” label
(inside the recessed area).
