XY Powersports XY500UTV, Service Manual

Page: 59 / 259

3. INSPECTION & ADJUSTMENT
3-18
Inspection of Lubrication System
Check Engine Oil Level
● Keep the engine in a plan position.
● Remove the fixture A, fixture B, then remove the left
side cover 1.
● Remove oil dip rod 2
● Clean oil dip rod, insert oil dip rod but do not tighten it.
● Take out oil dip rod and check if oil is between upper
and lower limit.
● If the engine oil is insufficient, fill more oil until the
sufficient oil is obtained.
Engine Oil: SAE10W/40 classification SF or SG
Replacing Engine Oil
● Remove left side cover 1, oil dip rod 2, drain bolt 3
and washer 4.
● Drain out the engine oil while the engine is still
warm.
● Clean oil dip rod, drain bolt and washer with solvent.
● Install washer and drain bolt.
Drain Bolt: 30 N.m
● Fill engine oil. ( about 1900ml)
● Install oil dip rod, start the engine and allow it to run
for several minutes at idling speed.
● Turn off the engine and wait for about 3 minutes,
and then check the oil level on the dipstick.
Replace engine oil and oil filter initially at 20
hours or 200km and every 80 hours or 2000km
thereafter.
Note:
● Keep the engine in a plan position
● Do not tighten oil dip rod when measuring oil
level