Xinje DS2 series, User Manual, Page: 88 / 99

80
8
Alarm Information
Alarm
Code Description Reason Solution
E-001 Program damage program self-test failed
Re-download the program or
contact Xinje or an authorized
distributor
E-002 Parameter damage
Parameter self-test
failed
Restart the drive to reset the
parameters. If it occurs for many
times please contact Xinje or an
authorized distributor
E-003 Bus over-voltage
Power grid is over
votage or need a
regenerative resistor;
the regenerative resistor
damage or its value is
too large
Check the power grid; connect
and check the regenerative resistor
E-004
Bus under
voltage Power grid is under
votage
Check the power grid
E-005
Regenerative
resistor error Regenerative resistor is
ineffective Check the connection of
regenerative resistor
E-006
Module over
temperature Run with large load for
long time
Reduce the load, and enhance the
cooling system, or check if the fan
is revolving when motor is ON;
cool down the ambient
temperature
E-007 Over current
UVW of drive is short
circiut or the motor is
error
Replace the damaged motor;
check the UVW wiring.
E-008 Over speed
Motor speed is too fast,
motor UVW
connection is error Check if there is other device that
make motor revolve too fast;
check the UVW wiring.
E-009 Analog input error
Input voltage error
when 2-channe analog
zero calibrating
Input correct voltage when zero
calibration for analog
E-010
Position offset too
large
The difference between
set position and actual
position exceeds the
limit value Check if the motor stalled,
decrease the set position speed,
increase offset pulse limit value
P5-05
E-011
Motor UVW is
short circiut External is short circuit
when fist self-test Check the UVW wiring of motor,
or replace the damaged motor
E-012
Motor UVW
current error Current collection
circuit error Check the UVW wiring of motor,
or replace the damaged drive
E-013
Encoder UVW
wire break
Encoder wiring error,
encoder broken,
encoder is not
connected Check the wiring of encoder, and
re-connect the encoder after
power-off, or replace the damaged
encoder
E-014 Encoder ABZ Encoder wiring error, Check the wiring of encoder, and