Xerox WorkCentre Pro 412, Service Manual

Page: 60 / 192

Circuit Description
WorkCentre Pro 412
Launch Issue
5-34
August 2001
5-6 OPE PBA
5-6-1 SUMMARY
OPE Board is separated functionally from the main board and operated by the micom(Z8601) in the board.
OPE and the main use UART (universal asynchronous receiver/transmitter) channel to
exchange information. OPE reset can be controlled by the main. OPE micom controls key-scanning and LCD
and LED display. If there occurs an event in OPE (such as key touch), it sends specific codes to the main to
respond to the situation and the main analyzes these codes and operates the system. For example, it the
main is to display messages in OPE, the main transmits data through UART line to OPE according to the
designated format and OPE displays this on LCD, LED. OPE’s sensing is also transmitted to the main through
UART line and then the main drives necessary operation.
OPE PBA consists of U1(MICOM, Z8601),LCD, key matrix, LED indicators. Refer to OPE Schematic
Diagram and Wiring Diagram sections of this manual.
• Signals from the key matrix are delivered to U1 input pin group (D1 to D6)
• U1 pin 48 (TX DATA) is the UART code sent to MAIN PBA.
• Display from the controller is received at U1 pin 5(RX DATA).
• LCD drive signals are sent from U1 P2-x pin group, P3-4 to P3-6 pins.
• Machine status LED drive signals are sent from U1 LED0 to LED7.
Connector
MICOM
Z8601
UART2
Reset
11
7
X
Y
8
RESONATOR
7.37 MHz
LCD
16u 2line
Key Matrix
LEDs
OPE BLOCK DIAGRAM