Xerox WORKCENTRE C2424, Service Manual

Page: 147 / 432

Error Messages and Codes 3-55
F2D
The front door open flag unexpectedly tripped while the system was warming up.
F2F
The front door open flag unexpectedly tripped while the system was in a fault state.
F2M
The front door open flag unexpectedly tripped when the system pick from Tray 2.
F2N
The front door open flag unexpectedly tripped when the system pick from Tray 3.
F2P
The front door open flag unexpectedly tripped when the system pick from Tray 4.
F2Q
The front door open flag unexpectedly tripped when the system pick from Tray 1.
F2R
The front door open flag unexpectedly tripped while the system was duplexing.
F2S
Front door sensor unexpectedly actuated while the paper was staged for transfix.
F2T
The front door open flag unexpectedly tripped while the print was being transfixed.
F2V
The front door open flag unexpectedly tripped while the system was oiling the drum
during a print job.
F2W
The front door open flag unexpectedly tripped while the system was imaging during
a print job.
F2X
Front door sensor unexpectedly actuated during exit.
1.
Ensure the media is supported.
2.
Ensure ground integrity of the system, see page 4-73.
3.
Run the diagnostic Sensors test to test the door sensor.
4.
Check that the doors and covers are properly closed and seated.
5.
Run the door sensor test.
G2M
Tray 2 removed during pick from Tray 2.
H2N
Tray 3 was removed during pick from Tray 3.
J2M
Tray 4 was removed during pick from Tray 4.
J2P
Tray 4 media present sensor event pick from Tray 4.
K2A
Exit module (MEP) malfunction during an abnormal IIT device shutdown.
K2B
Exit module (MEP) malfunction during a normal IIT device shutdown.
K2C
Exit module (MEP) malfunction during mechanical recovery.
K2D
Exit module (MEP) malfunction during warm-up.
K2E
Exit module (MEP) malfunction while in ready state.
K2F
Exit module (MEP) malfunction while in a fault state.
K2T
Exit module (MEP) malfunction during transfix.
Jam Code Troubleshooting Procedures
(Continued)